This standard is issued under the fixed designation A ; the 1 This specification is under the jurisdiction of ASTM Committee A01 on Steel. Purchase your copy of ASTM A – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. See the chemical composition and physical properties of ASTM A Grade Steel, find alternative materials, and connect with suppliers.
|Published (Last):||4 May 2013|
|PDF File Size:||4.33 Mb|
|ePub File Size:||3.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
This specification covers the standard for hot-rolled and cold-rolled alloy and structural aztm sheet and strip.
Siddhagiri Metals satm Tubes Rating: Hot Rolling is employed in breaking the ingots down into wrought products such as into blooms and billets, which are subsequently rolled to other products like plates, sheets, etc.
Two tension tests and two hardness tests shall be made from coupons obtained from each heat cast and heat treatment lot. This abstract is a brief summary of the referenced standard. Adtm material is pressed between a pair of rolls, which reduces the thickness and length is increased. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Alloy steel is furnished to chemical composition requirements and is intended primarily for general or miscellaneous use where bending and moderate forming is a requirement.
The material shall be furnished in several conditions: Historical Version s – view previous versions of standard. SI units are provided for information only.
Structural alloy steel is furnished to chemical composition requirements and to specific mechanical property requirements which may include tension tests, hardness tests, or other commonly accepted mechanical tests. Two tension tests and two hardness tests shall asym made from coupons obtained from each heat cast and heat treatment lot.
This Alloy Sheet are hot rolled or cold rolled. It is informational only and not an official part of the standard; the astj text of the standard itself must be referred to for its use and application.
ASTM A Alloy Steel Sheet Plate Strip Supplier Manufacturer Stockist
The ASTM A Sheet material is furnished in several conditions like heat treatments, such as hot-rolling and cold rolling; surface conditions; and edges, as astn herein, in coils or cut lengths. Rolling is the deformation of materials caused by compressive force applied through a set of rolls. Normally surface imperfections are not objectionable, and a good finish is not a prime requirement.
Siddhagiri Metals and Tubes Manufacturer: Link to Active This link will always route to the current Active version of axtm standard. Therefore, product design in relation to the mechanical properties of the grade used must be considered. Rolling is the most asgm industrial metal forming process. Heat analysis is performed on the material and is conform to the required chemical compositions for carbon, manganese, phosphorus, sulfur, silicon, copper, nickel, chromium, molybdenum, and vanadium.
ASTM A506 Grade 4118
Offer on Fasteners Sitemap. The cross section of the workpiece is reduced by the process. ASTM does not give any warranty express or implied or make any representation that the contents a50 this abstract are accurate, complete or up to date. Materials in the annealed, normalized, or normalized-and-tempered condition shall be capable of meeting the longitudinal bend test requirements.
Materials in the annealed, normalized, or normalized-and-tempered condition aztm capable of meeting the longitudinal bend test requirements.
Looking for some more information? Heat analysis shall be performed on the material and shall conform to the required chemical compositions for carbon, manganese, phosphorus, sulfur, silicon, copper, nickel, chromium, molybdenum, and vanadium.