ASTM E140 PDF

ASTM E Standard Hardness Conversion Tables for Metals Relationship Among Brinell Hardness, Vickers Hardness, Rockwell Hardness, Superficial. Hardness Conversion per ASTM E, Strength per ASTM A, See bottom half of table. Hardness C. Hardness Conversion Ta rdness Conversion Table. This standard is issued under the fixed designation E ; the number 1 These conversion tables are under the jurisdiction of ASTM Committee E28 on.

Author: Malagore Zulkigar
Country: Montenegro
Language: English (Spanish)
Genre: Career
Published (Last): 15 March 2016
Pages: 233
PDF File Size: 15.18 Mb
ePub File Size: 9.23 Mb
ISBN: 231-7-29622-161-3
Downloads: 21355
Price: Free* [*Free Regsitration Required]
Uploader: Gogal

Most Rockwell hardness numbers are presented to the nearest 0.

Referenced E1440 purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Differences in sensitivity within the range of a given hardness scale for example, Rockwell B may be greater than between two different scales or types of instruments.

Since all converted hardness values must be considered approximate, however, all converted hardness numbers shall be rounded in accordance with Practice E These hardness conversion relationships are intended to apply particularly to the following: Because of the wide range of variation among different materials, aastm is not possible to state confidence limits for the errors in using a conversion chart.

The equations given in Annex A10 were developed at the time the Leeb hardness test was invented see Appendix X2. It is recommended that hardness conversions be applied primarily to values such as specification limits, which are established by agreement or mandate, and that the conversion of test data be avoided whenever possible see Note 1.

  BOSCH LHM 0606 10 PDF

The equations given in Annex A1- Annex A9 were developed from the data in Tables 1 to 9, respectively. The conversion values, whether from the tables or calculated from the equations, are only approximate and may be d140 for specific application. Differences in sensitivity within the range of a given hardness scale for example, Rockwell B may be greater than between two different scales or types of instruments.

ASTM Hardness Conversion Chart

These hardness conversion relationships are intended to apply particularly to the following: The conversion values, whether from the tables or calculated from the equations, are only approximate and may be inaccurate for specific application.

Each type of hardness test is subject to certain errors, but if precautions are carefully observed, the reliability of hardness readings made on instruments of the indentation type will be found comparable.

Historical Version s – view previous versions of standard. Link to Active This link will always route to the current Active version of the standard.

Most Rockwell hardness numbers are presented to the nearest 0. Link to Active This link will always route to the current Active version of the standard. The data awtm Table 10 was calculated from the Annex A10 equations.

ASTM E140-07

This is because conversions can be affected by several factors, including the material alloy, grain structure, heat treatment, etc. Each type of hardness test is subject to certain errors, but if asgm are carefully observed, the reliability of hardness readings made on instruments of the indentation type will be found comparable.

  HABIBIE PRABOWO DAN WIRANTO BERSAKSI PDF

Since all converted hardness values must be considered approximate, however, all converted Rockwell hardness numbers shall be rounded to the nearest whole number in accordance with Practice E Active view current version of standard. Referenced Documents purchase separately The aztm listed below are referenced within the subject standard but are not aztm as part of the standard.

Even in the case of a table established for a single material, such as the table for cartridge brass, some error is involved depending on composition and methods of processing.